Fillet – Tutorial for beginners - AutoCAD tutorial

Category: AutoCAD tutorials > Basics - Difficulty:

This segment of tutorial exercise provides step by step instruction on creating a solid body using extrude tool.

If the line you are trying to extend does not intersect with the boundary line, you can use the "Edge" option to toggle Edgemode to "Extend" (the default is "No Extend").

Units and Scales - Discusses the commands used to control Units and Scales

The drawing here is a two-dimensional drawing by 2-d commands using two-dimensional drawing only(Lesson in Arabic)

This is an introduction to drafting in 3-D and progresses to more advanced methods.