Subscribe
Tutorial search

Defining Views On The Imported Drawing - Pro/ENGINEER tutorial


Drawing data imported to Pro/ENGINEER may or may not contain views. You can select drafting entities of the imported drawing and logically group them to represent views in AutobuildZ. You can define orthographic, detail, section and auxiliary views using the AutobuildZ view setup tools.
Category: Pro/ENGINEER > AutobuildZ - Difficulty:


More cool Pro/ENGINEER tutorials:



Pro/desktop An Introduction
Pro/desktop An Introduction
3D modelling software offers designers and manufacturers tools which make the transition from initial ideas to finished product faster, more accurate and of a higher quality. The use of 3D software in the context of modern manufacturing practice is outlined below.
Difficulty:
Relations - Documenting Design Intent - Demo
Relations - Documenting Design Intent - Demo
Add several relations to this flange to make the OD drive the number of slots. More...
Difficulty:
Removing Material (concept)
Removing Material (concept)
Some features are intended to specifically remove material from the model. Since these features remove material, they cannot be created until at least one other feature exists in the part.
Difficulty:
Assembly By Coord Systems - Application
Assembly By Coord Systems - Application
When you constrain one coordinate system to another, this single constraint is enough to fully constrain the component. This is one of the reasons that this method is so convenient.
Difficulty:
How To - 2d: Draw
How To - 2d: Draw
When a new design is created, the default view is isometric. Drawing shapes in isometric may be difficult in some cases. It may be more convenient to view onto the workplane by pressing Shift + w on the keyboard.
Difficulty: